No products in the cart.
Shop by CategoryShowing 1–12 of 48 results
12-Point Flange Screw (Ferry Socket Cap Screw)
12-point flange screw has a 12 point head and flanged bearing surface offering more torque and tighter gripping surface.
ACME
ACME threaded studs and all thread rod are appropriate for carrying heavy loads. A variety of thread pitches are available.
All Thread Rods (3′, 6′, 10′, 12′ lengths)
Fully threaded rods have threads from one end to the other.
Anchor Bolts (J-Bolts)
Anchor bolt is designed with the threads along the flat part. When the curved part is cast in concrete, the bolt is hooked in place. The threads remain exposed.
Bit Locs (Hex Socket Bit)
Our bit locs (hex socket bit) are tools used for socket drives.
Bottom Taps
Taps/Cuts threads to the bottom of a blind application. Has continuous cutting thread with very little taper.
Button Head Socket Cap Screw
Socket cap screw with a dome shaped head where the head has a wider and lower profile.
Coil – Rod
Coil-rod has widely spaced, shallow threads.
Concrete Screw
Concrete screws with hardened threads to anchor into materials such as concrete or brick.
Countersink Drills (Reamers) / Step Drills
Fluted countersink drills used for cutting countersunk holes to fit screws of varying head dimensions.
Custom Studs and Threads
Stud is a protruding rod, pin, or peg in machinery, used primarily as a support or pivot. Found as threaded, acme threaded, or coil-threaded.
Double-End, Single-End
Double-end stud has threads on two sides of the rod with multiple options available such as right-hand, left-hand, coarse or fine, etc.
