No products in the cart.
Shop by CategoryShowing 1–12 of 65 results
12-Point Flange Screw (Ferry Socket Cap Screw)
12-point flange screw has a 12 point head and flanged bearing surface offering more torque and tighter gripping surface.
A325/A490 Structural (Heavy Hex Bolts, TC)
Heavy hex bolt with flat and washer faced bearing surface and chamfered point.
ACME
ACME threaded studs and all thread rod are appropriate for carrying heavy loads. A variety of thread pitches are available.
All Thread Rods (3′, 6′, 10′, 12′ lengths)
Fully threaded rods have threads from one end to the other.
Anchor Bolt
Threaded anchor bolts threaded with L-hook or J-hook.
Anchor Bolts (J-Bolts)
Anchor bolt is designed with the threads along the flat part. When the curved part is cast in concrete, the bolt is hooked in place. The threads remain exposed.
Bit Locs (Hex Socket Bit)
Our bit locs (hex socket bit) are tools used for socket drives.
Bottom Taps
Taps/Cuts threads to the bottom of a blind application. Has continuous cutting thread with very little taper.
Button Head Socket Cap Screw
Socket cap screw with a dome shaped head where the head has a wider and lower profile.
Carriage Bolt
Carriage bolt with round head, square neck under the head, and a unified thread pitch.
Clevis
Clevis pin is part of a three-piece fastener (commonly called a shackle). Clevis pins have a domed head at one end and either a cross hole or threaded shank on the other.
Coil – Rod
Coil-rod has widely spaced, shallow threads.
